Spare parts recreated, even without a drawing
A plastic part broke and is no longer available? FV 3D-Manufaktur in Munich, Germany, redesigns it from the original, a photo or measurements and makes it in the right material, from a single piece. For businesses and private customers, with a written quote within 2 working days.
Updated:

- Quantity
- From 1 piece, or as a small batch
- Starting point
- Original part (even broken), photos, measurements or a drawing
- Materials
- PETG, ABS, ASA, PETG-CF, ASA-CF, PA6-CF, PLA
- Size
- Single parts up to about 25 cm per side, larger parts in sections
- Quote
- In writing within 2 working days
- Delivery
- Shipping across Germany, EU-wide for businesses, handover in Munich by arrangement
Which parts can be recreated?
Mainly plastic parts that break, wear out or can no longer be bought:
- Caps, covers, clips and trims
- Handles, knobs and dials
- Holders, tabs and fasteners
- Housing parts and panels
- Parts for machines, furniture, appliances, roller shutters and gardens
- Simple mechanical parts, after checking the load
What is needed for an enquiry?
Ideally the original part, or photos from several sides with a ruler or caliper in the picture. Add a few lines on where the part sits, what forces act on it and whether it is used indoors or outdoors.
If pieces are missing, the shape is completed from the remains, the mating part or further photos. A drawing or 3D file is not needed, but is welcome.
How does it work?
- Enquiry with photos, measurements or a description
- Written quote within 2 working days
- Measuring and design as a CAD model
- Sample for a fit test, adjusted until it fits
- Production of the required quantity
The approved model is kept. If the part is needed again later, it can be made without a new design.
Example: fence cap recreated


The caps on a garden fence were cracked and no replacement could be found. An old cap was measured, redesigned and made from weatherproof ASA in white. More in the examples.
Which material is right?
ASA or ASA-CF for outdoor use, as they resist UV and weather. PA6-CF for parts under load or heat, PETG for tough everyday parts. The weak point of the original can often be reinforced at the same time. More in the materials overview.
Frequently asked questions
Can a part be recreated without a drawing?
Yes. The original part or good photos with measurements are usually enough. The part is measured and redesigned as a CAD model.
What if the original part is broken?
Broken parts can usually be recreated too. Missing areas are completed from the fragments, the mating part or photos.
Is the replacement as strong as the original?
That depends on material and design. Often the weak point of the original is reinforced, for example with thicker walls or a stronger material such as PA6-CF.
Is it worth it for a single part?
Often yes, especially if the part is discontinued and the whole device would otherwise have to be replaced. Costs are stated in the written quote beforehand.
Can the original part be posted?
Yes, by arrangement. In Munich, a personal handover is also possible.
What determines the cost of a spare part?
Mainly the design effort, plus material, size and quantity. If a 3D file already exists, much of the design work falls away. The written quote comes before any work starts.
Is it allowed to copy a part?
Recreating a spare part for your own use is usually unproblematic. Copies of protected branded products for resale are not made.
A 3D file already exists. Can it simply be made?
Yes. STEP, STL or 3MF files are checked and adjusted for material and application if needed.
Are clips and parts for car interiors made too?
Yes, for example clips, covers or holders, in heat-resistant ABS or ASA. Load-bearing or safety-relevant vehicle parts are not made.

